3D Printing Filament Break Detection Module - Upgrades - Xbotics View larger

Online only

3D Printing Filament Break Detection Module - Upgrades - Xbotics

New product

Coming Soon

when there is filament, the green light of the module is always on. When the material is used up, the green light is off. The main board executes the pause command operation, waiting for the person to replace the material and then continue printing. Telecom motherboard wiring: M-sensor port on the motherboard.

More details

This product is no longer in stock

₹ 0.00 tax excl.

Add to wishlist

More info

Used on other motherboards: used to detect the signal level jump detection. When there is material, the detection port level signal should be high level. When there is no material, the material port level signal becomes low level, and the system detects one. If the determined high-to-low transition occurs, the material is considered to be exhausted, a pause command is executed, and the person continues to print after waiting for the replacement of the material.
- Specifications: suitable for 1.75mm material testing

* Product Images are shown for illustrative purposes only and may differ from actual product.

Check out all of our categories

https://xbotics.in

http://xbotics.in/12-aerial-botics

http://xbotics.in/13-ground-botics

http://xbotics.in/15-iot

http://xbotics.in/16-3d-printing

http://xbotics.in/17-composites

http://xbotics.in/103-drone-parts

4 other products in the same category: