The 220 x 220 x 3mm Frosted Heated Bed Sticker Build Plate Tape With Adhesive Backing For 3D Printer, the heatbed sticker is made of special rough PC chip, not only can prevent 3D printing models Alice edge but keep the surface smooth.
10 Item Items
Warning: Last items in stock!
1.The product is divided into two sides of the A.B board.
A side:High temperature print layer B side:Low temperature adhesive layer
2.Separate bending to take the model. It is more convenient.
3.No need for beautiful paper and scrapers to assist the model.
4.Can be installed on hot bed and glass platform.
5.Printing does not warp. No glue is needed.
6.Can be printed on a cold bed.
7.The A plate is flexible and magnetic, easy to move away from the build platform, take away the print model
8.Ours is PC material, short-term temperature resistance of 180 degrees, long-term 130 degrees. More than 130 degrees of magnetic properties will be weakened but will not lose magnetism, so can be applied to PLA/ABS and other filament.
9.PC material is flame retardant and wear resistant. Oxidation resistance, low mold shrinkage, good dimensional stability
10.A B board is flat，It can better reduce printing errors and make the printed model more standard
Material: Special Glass + microporous coatings
Temperature settings for different filaments:
Item Size: 220 * 220 * 3mm
* Product Images are shown for illustrative purposes only and may differ from actual product.
Check out all of our categories