1 Channel 5V Relay - Relay - Xbotics View larger

1 Channel 5V Relay - Relay - Xbotics

New product

A relay is an electrically operated switch. Many relays use an electromagnet to mechanically operate a switch, but other operating principles are also used, such as solid-state relays. Relays are used where it is necessary to control a circuit by a separate low-power signal, or where several circuits must be controlled by one signal.

More details

50 Items

₹ 200.00 tax excl.

Add to wishlist

More info

This 1-channel 5V control Single-Pole Double-Throw (SPDT) High-level trigger AC power relay board can be controlled directly via a microcontroller and switch up to 10A at 250 VAC. The inputs of 1 Channel 5V 10A Relay Module are isolated to protect any delicate control circuitry.

The default state of the relay when the power is off for COMM (power) to be connected to NC (Normally Closed). This is the equivalent of setting the relay board IN pin to HIGH (has +5v sent to it).

When you have power connected to the relay’s NO (Normally Open) connector and you set the corresponding IN pin to LOW (0V, or Ground), power will flow in from the COMM connector and out of the NO, connector powering your device.

Pin Configuration:

1 Channel 5V 10A Relay Module

 

Connection Diagram:

1 Channel 5V 10A Relay Module


Features :

  1. 1 channel relay board
  2. One normally closed contact and one normally open contact
  3. Triode drive, increasing relay coil
  4. High impedance controller pin
  5. Default Trigger: High-level trigger
  6. Pull-down circuit for the avoidance of malfunction
  7. Power supply indicator lamp
  8. Control indicator lamp
  9. Indicator for Relay output status
  10. Can Be controlled various appliances & other Equipment With Large current.
  11. Standard TTL Level logic controlled (AVR, Arduino, 8051, PIC, ARM)
  12. The module is compliant with international safety standards, control and load areas isolation trenches;
  13. With 4 fixed screw holes, hole diameter 3.1mm, convenient installation, and fixation

SPECIFICATION:

Operating Voltage(VDC)

5

Max. Current(mA)

20

Current Capacity at AC250V

10A

Current Capacity at DC30V

10A

Length (mm)

38

Width (mm)

26

Height (mm)

18

Weight (gm)

13

* Product Images are shown for illustrative purposes only and may differ from actual product.

Check out all of our categories

https://xbotics.in

http://xbotics.in/12-aerial-botics

http://xbotics.in/13-ground-botics

http://xbotics.in/15-iot

http://xbotics.in/16-3d-printing

http://xbotics.in/17-composites

http://xbotics.in/103-drone-parts

15 other products in the same category: