2PCs 0.96 OLED Display ESP32 WIFI Bluetooth Lora Development Board Transceiver SX1276 868MHz IOT with Antenna FZ2886 - Xbotics View larger

2PCs 0.96 OLED Display ESP32 WIFI Bluetooth Lora Development Board Transceiver SX1276 868MHz IOT with Antenna FZ2886 - Xbotics

New product

WIFI Kit series is the new development of the cost-effective networking program, the main chip using ESP32, LX6 dual-core processor,  computing power up to 600DMIPS, chip built-in 520 KB SRAM, 802.11 b / g / N HT40 Wi-Fi transceiver, baseband, protocol stack and LWIP, integrated dual-mode Bluetooth (traditional Bluetooth and BLE low power Bluetooth).
 

More details

10 Items

₹ 5,150.00 tax excl.

Add to wishlist

More info

 This product is based on the WIFI Kit 32 added SX1276 chip, that is, LoRa ™ remote modem, Applicable frequency:868MHz -915MHz frequency, about -148dBm high sensitivity, +20 dBm power output, high reliability, transmission distance (measured open area communication distance 2.6Km).
 
 
Onboard 32MByte Flash, Wi-Fi antenna, 0.96-inch blue OLED display, lithium battery charging circuit and interface, CP2102 USB to serial chip, the perfect support for Arduino development environment, can be very simple and fast for program verification and product development.
 
Technical Parameters:
 
Main chip: espressif esp32 and SX1276
Operating voltage: 3.3V to 7V
Flash:32M-Bits
Main Frequency:240MHz
Support frequency:868-915MHz
Lora chip:SX1276
Distance: about 2.8KM in open place
Computing power: 600DMIPS
Dual-mode Bluetooth: traditional Bluetooth and BLE low-power Bluetooth
Development environment: support arduino
USB adapter chip: cp2102
Operating temperature range: -40 ° C to + 90 ° C
Support modes: Sniffer, Station, softAP and Wi-Fi Direct  
Data rate: 150 Mbps @ 11n HT40,72 Mbps @ 11n HT20,54 Mbps @ 11g, 11 Mbps @ 11b
Transmit power: 19.5 dBm @ 11b, 16.5 dBm @ 11g, 15.5 dBm @ 11n
Receiver sensitivity up to - 98 dBm
UDP continues to throughput by 135 Mbps
 
U.FL IPEX to SMA Connector Antenna 868MHz for Lora Board Lora32u4 II Wifi Lora32
 
Connector type: ipex
Band definition: 868MHz
Standing wave ratio: <= 1.5
Gain: 3dBi
Maximum power: 10W
Input impedance: 50Ω
 

8 other products in the same category: