APM 2.6 Flight controller - Flight Controller - Drone - Xbotics View larger

APM 2.6 Flight controller - Flight Controller - Drone - Xbotics

New product

APM 2.6 Multicopter Flight Controller is an upgraded version of 2.5; with a Built-in Compass for FPV RC Drone Aircraft is the new APM (Ardupilot Mega) 2.6, flight controller. The sensors are exactly the same as the APM 2.6 flight controller, however, this has the option to use the built-in compass, or an external compass via a jumper.

More details

10 Items

₹ 2,850.00 tax excl.

Add to wishlist

More info

The APM 2.6 Multicopter Flight Controller is a complete open source autopilot system and the bestselling technology that won the prestigious Outback Challenge UAV competition. It allows the user to turn any fixed, rotary wing or multirotor vehicle (even cars and boats) into a fully autonomous vehicle; capable of performing programmed GPS missions with waypoints.

This revision of the board has an optional onboard compass, which is designed for vehicles (especially multi-copters and rovers) where the compass should be placed as far from power and motor sources as possible to avoid magnetic interference. (On fixed wing aircraft it’s often easier to mount APM far enough away from the motors and ESCs to avoid magnetic interference, so this is not as critical, but APM 2.8 gives more flexibility in that positioning and is a good choice for them, too). This is designed to be used with the 3DR uBlox GPS with Compass so that the GPS/Compass unit can be mounted further from noise sources than APM itself.

APM 2.6 Multicopter Flight Controller requires a GPS unit for full autonomy. You can add additional extras to your AMP 2.8 board via the options above.

Using the built-in compass

To use the built-in compass simply connect the jumper as shown below.  If the compass jumper is removed then the APM board will use the external compass which is best for multirotor with a GPS/compass module mounted externally




The downloadable mission planner software is what you use to configure and control your Ardupilot board, features include:

  1. Point-and-click waypoint entry, using Google Maps.
  2. Select mission commands from drop-down menus.
  3. Download mission logs files and analyzes them.
  4. Configure APM settings for your airframe.
  5. Interface with a PC flight simulator to create a full hardware-in-the-loop UAV simulator.
  6. See the output from APM’s serial terminal.



APM 2.6

Power supply



MUX (UART0, UART2, mnnI2, and OSD are optional, OSD is the defaulted output).

Input Voltage (V)

12~16 VDC


3-Axis Gyrometer
High-performance Barometer


ATMEGA2560 and ATMEGA32U-2

Micro-SD Card Slot


Dimensions (mm) LxWxH

85 x 45 x 15

Weight (gm)


* Product Images are shown for illustrative purposes only and may differ from actual product.

Check out all of our categories








29 other products in the same category: