No products
Connectors and Wires
Connectors and Wires for drones
Connectors and Wires There are 19 products.
-
XT60 Battery Connectors one piece
This is an Excellent W.S. Deans T-connector replacements. Made from high-temp Nylon and gold plated spring connectors, both included in the injection mold at the time when forming the connector
₹ 64.90Online onlyIn Stock -
16AWG silicone wire red & black (1m each)
The High-Quality 16AWG Silicon Wire 1m (Red) has a pretty big diameter as compared to the normal 20AWG wire used in RC projects for serving its specific purpose. This wire has low resistance and high current carrying capacity. These are also used in LiPO batteries to deliver power to ESC’s.
₹ 389.40Online onlyIn Stock -
30mm female to female servo lead 26AWG one...
This is a 12 inch Servo Extension with J Connectors. On one end of the wire is a male "J" connector and on the other end of the wire is a female "J" connector
₹ 0.00Online onlyIn Stock -
Multirotor XT60 connector fixed mounting...
Protect your multirotor ESC / battery connectors from impact or prop damage with these handyPCB's. Simply solder your Male XT60 connector directly to the board and secure to your multirotorframe with some 3mm nuts and bolts.
₹ 0.00Online onlyOut of stock -
Heat Shrink tubes 5mm (red,yellow,black)...
Heat Shrink Sleeve 5mm Black,white,yellow 1 meter Industrial Grade WOER (HST) are excellent for insulation. They have exceptional insulation characteristics, excellent stress control properties; long-term weather and regular wear and tear resistance, ease of installation and reliable performance in even in harshest of the situations.
₹ 41.30Online onlyIn Stock -
Heat Shrink tubes 8mm (red,yellow,black)...
Heat Shrink Sleeve 8mm Black,white,yellow 1meter Industrial Grade WOER (HST) are excellent for insulation. They have exceptional insulation characteristics, excellent stress control properties; long-term weather and regular wear and tear resistance, ease of installation and reliable performance in even in harshest of the situations.
₹ 53.10Online onlyIn Stock -
Heat Shrink tubes 12mm (red,yellow,black)...
Heat Shrink Sleeve 12 mm Black,white,yellow 1meter Industrial Grade WOER (HST) are excellent for insulation. They have exceptional insulation characteristics, excellent stress control properties; long-term weather and regular wear and tear resistance, ease of installation and reliable performance in even in harshest of the situations.
₹ 70.80Online onlyIn Stock -
3.5 mm Gold Connector/ Bullet Connector...
3.5mm Gold Connectors Male/Female Pair Gold Connectors has Quality 4 mm sprung gold connectors can handle the large current, perfect for 3500mAh or larger capacity batteries or 80A+ systems. Our gold connectors are well machined and gold plated with a rear side-cut for easy soldering.
₹ 47.20Online onlyIn Stock -
Male to Female signal wire 26AWG
The SafeConnect Flat 60 CM 26AWG Servo Lead Extention (Futaba) Cable are stronger & allow more current than standard servo wires. Great for larger planes with servos that experience high loads.
₹ 0.00Out of stock -
APM Power Module
The APM Power Module is a simple way of providing your APM with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable.
₹ 1,003.00Online onlyIn Stock -
8 in 1 throttle calibration hub -...
This 8 in1 Throttle Calibration Hub for RC Multirotor ESC Speed Controller supports up to 8 ESCs; making it ideal for a tricopter/quadcopter/hexacopter/octocopter setup; just plug the 3/4/6/8 ESC wires into the hub. We need to plug one wire from the hub to our throttle channel on the receiver.
₹ 295.00Online onlyIn Stock -
Matek Mini Power Distribution Board for...
This PDB distribution power from from a 3-6S Lipo pack to 4 ESCs, as well as providing regulated & filtered DC 5V & DC 10V outputs for powering Cameras, RC receivers, Flight Controllers, Video Transmitters, LEDs, etc.- It also has buit-in 184A current sensor and offers a FFC socket to connect the Matek flight controller conviently.
₹ 531.00In Stock
